The Ai-1203 Ball Joint Delete™ System is a press-fit kit with a same install method as a factory joint. It features a split-tapered bushing which expands as preload is added to the assembly ensuring a precise fit. The customer can trim the top flange of the bushing based on caster/camber needs, the kit includes instructions on setup and trimming.
- 7075 Aluminum Split-tapered bushings in 0 degree
- Huge 1.625" Teflon lined Spherical Bearings with 7/8" bores
- All assemblies are greased and lubricated
- 7/8″ 4140 Hardened custom spec bolts
- 7/8″ Low profile locknut
- Ideal for stock height trucks
- **** INSTALLATION INSTRUCTIONS CLICK HERE ****
Fitment: The Ai-1203 is the perfect solution to a stock height truck simply looking for a better joint without any maintenance. Lower joints are holding the majority of the weight of the truck and typically see less failures but are susceptible to “push out.” This happens when a shaft breaks and pushes the joint out the bottom of the knuckle. The lower system uses the same basic design as the upper, with a 1 piece stud with taper to match the tapered hole in the knuckle.
Swapping this axle under your Jeep and have a good pinion angle? Simple trim the flat on the 0 degree bushing and you have the absolute best of both worlds- a perfect driveline angle, ideal caster, AND an unbreakable joint on top of it. ABSOLUTELY NO ONE ELSE IN THE INDUSTRY GIVES THIS LEVEL OF STRENGTH AND RIG-SPECIFIC ADJUSTABILITY.
What is a Ball Joint Delete™ System and why do you need it? Learn more from American Iron Offroad™ founder Josh Dodsworth:
Don't take our word for it, hear from real world drivers that use our products and put them to the test everyday.
Tony Pellegrino Founder of GenRight Offroad
Jon Schaefer Founder RPM Extreme
Scott Durkin Driver of the Trail Reaper
Roger and Amber Betancourt
